Acan barcode manual






















NETUM C C Quick Start Manual. W6-X, W8-X Quick Start Manual. W3 Quick Start Manual. NT-R2 NT-R3 Quick Start Manual. NT-Z2S NT-Z3S Quick Start Manual. Prefix and Suffix Command Barcodes for All Bluetooth Scanner. Prefix+suffix Command Barcode for 1D Laser Scanner. NETUM C/C SDK. on time of seconds, scan the bar code below, then scan the "0", "0" and "5" bar codes; to set an on time of seconds, scan the bar code below, then scan the "1", "0" and "5" bar codes. To change the selection or cancel an incorrect entry, scan Cancel in appendix. Duration in Scanning(Default: sec.) www.doorway.ru Interval of The Same Code. GS-MBT series bluetooth barcode scanner are divided into high density and low density model. Optimal scanning distance of Low density model is www.doorway.ru density model 's scanning distance is www.doorway.ru can read higher density barcode like 3mil. GS-MBT series 2D bluetooth barcode scanner 's best scanning distance is 7cm cm.


This scanner will automatically scan a barcode at a distance of 3 to 8 inches from the symbol when the trigger is pulled. The scanner is programmed by scanning barcodes from the manual when viewed on the screen at % or more magnification from the PDF. Successful scanning shall be obtained by tilting the scanner with respect to the. Items per page Acan» Barcode Scanners» Hand-Held» CCD. Model; Acan FG Acan CCD hand held barcode scanner. Купить можно в магазине www.doorway.ru за руб. ACAN USB Laser Handheld Barcode Scanner/Reader for Desktop/Laptop.


setting barcode B:Select the desired contents of prefix or suffix(Appendix A) www.doorway.ru”Exit add prefix and suffix mode”Setting-up Barcode www.doorway.ru you need remove both the prefix and suffix, please scan”remove all prefix” or”remove all suffix” Allow for Prefix Adding Allow for Suffix Adding Exit add prefix and suffix mode. Barcode reader setup manual Setup procedures are as follows 1 Scan Begin setting 2 Scan your required function and its corresponding barcode 3 Scan End setting 4 All the setting parameters will be saved after scanning Save setting parameter 5 All the settings will be returned to the manufacture default parameters after scanning Setup the manufacture parameters. Scanner does not decode bar code Scanner not programmed for bar code type Enable that bar code type Bar code is unreadable Ensure the bar code is no t defaced; scan a test bar code of the same bar code type Bar code is out of aiming line area Mo ve the aiming line over the bar code Scanned data incorrectly displayed on host.

0コメント

  • 1000 / 1000